ELECTRONIC LED FREQUENCY METER

DSC_0013

Description :

It is used to measure the applied frequency, functionally similar to vibrating reed meter. The meter incorporates light emitting diodes LEDs which are used instead of vibrating reeds to indicate applied frequency. The frequency is determined by blinking LEDs. When applied frequency matches with the frequency marked on the dial, that particular LED blinks with maximum intensity. When the applied frequency is mid way between two adjacent LEDs, both LEDs blink. When the meter is switched on all the LEDs glow sequentially for a period of 1 to 1.5 seconds, thereafter it will indicate the applied frequency.

All voltage ranges are available in single meter. Terminal screws with washers are provided only for specific voltage as per requirement & remaining two terminals are covered with insulated caps. In case of 96mm & 144mm instruments, two sets of LEDs with the same scale range can be offered, giving two independent meters in one casing (Dual Scale). This facilitates in comparing the frequency of two voltage supplies for paralleling operation.

Download  

Features :

  • No vibrating parts.
  • No aging effect.
  • Faster response.
  • Lighter in weight.
  • Low power consumption
  • No effect of external vibration
  • Visible in dark & from distance.

Electrical Specifications :

Type : Electronic
Operating Voltage : 110V~125V, 220V-250V, 380V~440V.
Power Consumption : less than 3VA (single scale), less than 6VA (double scale).
Measuring Method : time measurement between consecutive cycles.
Display : box led, colour red/green, size 6.3 x 3.7mm
Sampling Rate : 2-3 samples/sec.
Response Time : less than 1 sec.
Insulation Resistance : greater than 20 mohms at 500v DC.
Dielectric Strength : 2KV RMS for 1 minute.
Operating Temp : -10°C to 55°C
Storage Temp : -20°C to 70°C
Humidity : upto 95% RH
Conforms To : I.S. 1248 / B.S. 89. / I.E.C. 51. (part - 4)

Available Ranges :

ID Electronic LED tab-1

% of center Frequency

  Available Models

* There are 11LEDs in a row in steps of 1Hz for range (45-50-55Hz)/(55 – 60 – 65Hz) with additional 2 LEDs for (49.5 and 50.5Hz) / (59.5 and 60.5Hz) respectively.

Terminal Arrangement :

ID Electronic LED fig-2
ID Electronic LED fig-3

Ordering Information :.

1) Type 2) Model 3) Range 4) Operating Voltage